THIS LIMITED WARRANTY DOES NOT COVER THE CARTRIDGE 104 FOR WHICH A SEPARATE WARRANTY IS GIVEN.
Canon super g3 printer phantom paper jam series#
Inc., (“Canon USA”) with respect to the Canon imageCLASS MF4300 Series packaged with this Limited Warranty (the “Product”) and which is purchased and used in the United States, subject to the conditions below. The limited warranty set forth below is given by Canon U.S.A. Version 1.Canon imageCLASS MF4300 Series LIMITED WARRANTY Gently pull out any sheets of paper by rolling the knob as illustrated below. If you cannot pull out the jammed paper, proceed to the next step. Gently pull out any sheets of paper with both hands.
Reload the transparencies into the MP tray. Be careful not to tear the jammed transparency. Then, gently pull out any transparencies with both hands. Open the MP tray cover and remove all transparencies that are loaded. When transparencies are jammed, follow the steps below to clear the jam. If the jammed paper is not visible inside the optional paper cassette unit, or to check if there is any jammed paper inside cover G, proceed to step 4. If you find any jammed paper, gently pull out any sheets of paper that have fed part way into the product. Pull out the paper cassette from the optional paper cassette unit. Reload the paper and close the MP tray cover.Īfter removing the jammed paper from the MP tray, you need to open and close any cover except the MP tray cover to clear the error message.įollow the steps below to clear paper jams at the optional paper cassette unit and cover G. Gently pull out any sheets of paper that have fed part way into the product.
Open the MP tray cover and remove all paper that is loaded. Push down the two green levers on the fuser unit, then close cover C.įollow the steps below to clear paper jams at the MP tray. Open cover C, then raise the two green levers on the fuser unit to unlock it. Be careful not to tear the jammed paper.įollow the steps below to clear paper jams at cover F. Lower the scanner unit to the original position.įollow the steps below to clear paper jams at cover E. Push down the two green levers of the fuser unit. Hold the guide up by holding the green tab, and gently pull out any sheets of paper. Raise the two green levers of the fuser unit to unlock it. Touching it will cause the document cover of the scanner unit to fall down, which may damage the product and cause injury. If the product has been in use, the fuser and the surrounding areas may be very hot.ĭo not insert your hand deep into the fuser unit as some components are sharp and may cause injury.įollow the steps below to clear paper jams at cover C.īefore raising the scanner unit, make sure that the document cover is closed firmly.ĭo not touch the lever under the scanner unit when you open or close the unit. Make sure that the paper type that is loaded is the same as the Paper Type setting in the printer driver.īe careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE, or the surrounding areas. If jammed paper is torn and remains in the product, or if paper is jammed in a place not mentioned in this section, contact your dealer. Pull it gently in order to avoid tearing.Īlways try to remove jammed paper with both hands to avoid tearing it. Torn paper can be difficult to remove and might cause other paper jams. The product's LCD panel and EPSON Status Monitor 3 provide alert messages.Ĭlear the paper jam by following the order of the indicated cover names displayed on the control panel or EPSON Status Monitor 3.īe sure to observe the following points when you clear jammed paper.ĭo not remove jammed paper by force. If paper becomes jammed in the product, the Print light (green) goes off and Error light (red) is lit. When transparencies are jammed at the MP tray
Jam LC/G (optional paper cassette and cover G)